Phone photography support · SKU guide

UGREEN Bluetooth Selfie Stick Tripod with Remote (15062)

UGREEN 15062 combines a handheld selfie stick, extendable monopod and freestanding phone tripod in one folding body. It extends to approximately 150cm and folds to about 32cm for transport.

Overview

The integrated clamp rotates through 360° and the head provides up to 203° of angle adjustment. A detachable Bluetooth 5.0 shutter remote lets a compatible phone camera app take a photo from up to a listed 10m under suitable conditions.

This is a lightweight phone-content accessory. Tripod stability decreases as the pole is extended, especially outdoors, on uneven surfaces or with an off-centre device.

Performance and planning

Plan around the complete setup, not a headline alone. Fit, stability and protection depend on the attached device, surface, loading, handling and surrounding conditions.

The 150cm figure describes pole extension, not guaranteed stable working height in every environment. Use the shortest height that achieves the shot and keep the centre of mass over the tripod base.

The listed 10m remote range is a clear-line planning ceiling. Nearby radio traffic, phone settings, walls and battery condition can shorten reliable distance.

A manufacturer photo-count claim cannot predict real battery life. Storage age, temperature, pairing and use pattern affect the CR1632 cell.

The light 369g body is easy to carry but is more sensitive to wind, bumps and an off-centre heavy phone than a full-size photographic tripod.

Setup and usability guidance

Use this sequence for a deliberate first setup. Follow the connected-device maker’s stricter instruction whenever it differs.

1. Remove the phone case only if the phone-plus-case width exceeds the 5.8–8.2cm clamp range or prevents secure pad contact.
2. Open the clamp, centre the phone between the padded jaws and confirm no side button is continuously pressed.
3. Choose portrait or landscape orientation, then tighten or seat the head so the phone cannot rotate freely.
4. For tripod use, open the legs fully on a flat, firm surface and start with the pole collapsed.
5. Extend each pole section gradually and stop at the lowest height that achieves the framing. Recheck balance after every adjustment.
6. Remove the shutter remote, enable Bluetooth on the phone, select the remote when it appears and test one photo at arm’s reach.
7. Before stepping away, lightly test stability from several directions without letting go of the phone.
8. Collapse the pole before moving the assembly; remove the phone before folding or packing the legs.

What this product does

These are the product’s supported physical functions when it is selected and used correctly.

• Supports a compatible phone for handheld or stationary framing.
• Extends from a compact carry length to approximately 150cm.
• Changes phone orientation and tilt within the joint ranges.
• Provides a detachable Bluetooth camera shutter button for compatible phone apps.
• Folds the tripod base into the handle for storage.

What to do

These habits improve day-to-day usability and help protect devices, cables and surfaces.

• Centre the device in the clamp and keep its mass over the tripod base.
• Use the lowest practical extension and check every pole section before releasing the phone.
• Test Bluetooth shutter operation before joining a group shot.
• Keep the setup within reach or continuously supervised.
• Collapse the pole and remove the phone before relocating the tripod.
• Store the CR1632 cell and remote away from children and pets.

Warnings and limitations

Review these limits before using the product around valuable equipment, power cables, children or pets.

• A fully extended lightweight tripod can tip suddenly. Wind, a bumped leg or an off-centre device substantially reduces stability.
• Keep the mounted device away from ledges, roads, crowds, pools and locations where a fall can injure someone or damage property.
• Coin cells can cause severe injury if swallowed. Keep the CR1632 and remote battery compartment away from children and seek urgent medical help if ingestion is suspected.
• Bluetooth range and app response vary. Confirm the phone saved the image before ending an important session.
• Inspect the clamp pads, leg hinges, telescoping locks and mount before each use; stop if any part is cracked or loose.
• Do not use during thunderstorms, on conductive structures or in conditions that wet the mechanism or electronics.

Package contents

Only components supported by the current model record or gallery are listed. Connected devices and scene props are not included.

• 1 × UGREEN 15062 folding selfie-stick/tripod assembly with integrated phone clamp
• 1 × detachable Bluetooth shutter remote with CR1632 coin cell identified in the gallery
• Mounting pieces shown with the unit for its supported phone/compact-camera roles; phone, action camera and storage bag are not identified as included.

Care and troubleshooting

Use gentle cleaning and change one variable at a time when diagnosing fit, stability or cable-routing problems.

• Remove the phone and collapse the pole before wiping the body with a soft dry or barely damp cloth.
• Keep grit out of telescoping sections and hinges; never oil the phone clamp or remote compartment.
• If the remote will not pair, remove the old phone entry, confirm the battery orientation and retry nearby with other paired shutter devices disconnected.
• If photos do not trigger, test the phone’s native camera app and its volume-button shutter setting.
• If the tripod leans or vibrates, shorten the pole, recenter the phone, spread the legs fully and move to a firmer sheltered surface.