UGREEN exact-model networking guide · SKU 11282
UGREEN 3m Cat6 F/UTP Ethernet Extension Cable (11282)
An exhaustive, practical guide to the exact connector path, verified performance, construction, setup, compatibility, safe use and troubleshooting.
Product overview
Overview
UGREEN 11282 is a 3m Cat6 F/UTP Ethernet extension lead. Its RJ45 female socket accepts an existing male patch-cable plug, while its attached RJ45 male plug reaches the destination port. It is listed for Up to 1000Mbps (1Gbps) and uses 8 × 26awg stranded pure-copper conductors arranged as four twisted pairs. It extends a physical cable; it does not regenerate, amplify or repeat the network signal.
The buying decision begins with the exact interfaces and application, not the largest printed number. Confirm that the physical ports, protocol, device software and complete route match this model.
Product highlights
Key features
3m
Exact model format or length for planning the physical connection.
Up to 1000Mbps (1Gbps)
Verified product capability, subject to the complete host or network path.
RJ45 male → female
The defining connector, protocol or construction detail for this exact SKU.
One clear job
Adds 3m of physical reach to an existing male RJ45 Ethernet patch cable.
No hidden upgrade
It does not boost, repeat, clean or regenerate an Ethernet signal.
Exact media only
All 7 current Shopify-owned product images were reviewed; embedded images remain attached to SKU 11282.
Port and direction check
Choose the right connection
1 × shielded RJ45 male plug to 1 × RJ45 female inline socket
Ethernet data is bidirectional, but the physical use is specific: plug the existing patch cable into the female socket and insert the extension cable’s male plug into the destination RJ45 port.
Inspect port labels and connector shapes under good light before routing. A physically similar socket may serve telephone, console, management, USB or power rather than the network job described here.
Speed, bandwidth and negotiation
Verified network performance
Maximum listed cable mode: Up to 1000Mbps (1Gbps). Current exact artwork uses a 250MHz Category 6 reference in exact artwork. The joined channel is governed by the lowest-category cable, weakest junction, slowest port and total installed length.
A maximum link rate is not the same as measured payload throughput. Protocol overhead, storage speed, CPU load, router processing, remote servers and internet service can all reduce the number shown by an application.
For a useful test, first confirm the negotiated link rate, then run a local transfer between capable devices before testing a public speed service.
Physical build
Shielding, conductors and construction
F/UTP construction, 8 × 26AWG stranded pure-copper conductors arranged as four twisted pairs, 1 × shielded RJ45 male plug and 1 × RJ45 female inline socket with gold-plated contact wording, round Black PVC jacket.
| Cable category | Cat6 |
|---|---|
| Precise shielding | F/UTP |
| Conductors | 8 × 26AWG stranded pure-copper conductors arranged as four twisted pairs |
| Gauge | 26AWG |
| Cable form | Round; Approximately 6.2mm on the exact product record |
| Connector pair | 1 × shielded RJ45 male plug and 1 × RJ45 female inline socket with gold-plated contact wording |
| Outer jacket | Black PVC |
Construction details describe this exact product only. They must not be borrowed from another length, family member or visually similar adapter.
Where it fits
Use scenarios
Existing patch lead stops short
Add up to 3m of physical reach without replacing an otherwise suitable male-to-male RJ45 patch cable.
Desk or office move
Reposition a computer, printer or docking station while keeping the female junction supported and accessible.
Hotel or temporary workspace
Bridge a small indoor distance from an existing Ethernet lead to a laptop or compact router.
Console or television setup
Extend a wired connection to a compatible RJ45-equipped console, smart television or media player.
Cable-management correction
Move a junction away from a strained device port, provided the complete channel remains within Ethernet length and performance limits.
A reliable first connection
Setup and usability guidance
Follow a controlled sequence so connector, network and software faults remain easy to isolate.
- Confirm UGREEN SKU 11282, the required 3m reach and an existing male RJ45 patch lead.
- Inspect the female socket, male plug and existing patch-cable latch for damage or debris.
- Insert the existing male RJ45 plug into the extension socket until it clicks.
- Connect the extension cable’s male RJ45 plug to the destination LAN port.
- Support the female junction so it does not hang by either cable and keep it out of foot traffic.
- Check link lights and negotiated speed, then run a local transfer test.
- If performance drops, test each original cable directly and replace the weakest or damaged component.
Compatibility explained
Compatible devices and systems
Compatible endpoints
- Computers, docks and network adapters with RJ45
- Routers, switches, gateways and access points
- Smart TVs, consoles, media boxes and network printers
Required existing cable
- A standard male RJ45 Ethernet patch cable
- A cable category suitable for the intended channel speed
- An undamaged latch and clean connector contacts
Channel behaviour
- Backward compatible with 100Mbps and 10Mbps links
- Maximum 1Gbps only on a suitable complete channel
- No driver or external power required
Compatibility is conditional. A device name or logo in product artwork identifies a use category, not universal support for every hardware revision, operating system, driver, network mode or accessory chain.
Supported jobs
What this product does
Use SKU 11282 for these verified roles.
- Adds 3m of physical reach to an existing male RJ45 Ethernet patch cable.
- Creates a removable male-to-female inline extension without a separate coupler.
- Supports up to Up to 1000Mbps (1Gbps) on a compatible complete channel.
- Carries bidirectional Ethernet data and allows ordinary auto-negotiation.
- Uses copper twisted pairs and shielded construction described for this exact SKU.
- Works without a software driver or external power supply.
Each role stays within the product category described above; it does not imply conversion, amplification, routing or software support that is not listed.
Important exclusions
What this product does not do
These exclusions prevent the most common wrong-product purchases and unsafe installations.
- It does not boost, repeat, clean or regenerate an Ethernet signal.
- It does not add 3m beyond the applicable total Ethernet channel limit.
- It does not convert USB, telephone, fibre or coaxial networking into Ethernet.
- It does not make a slower existing cable or port operate at 1Gbps.
- It does not provide an independently verified PoE class or wattage.
- It does not have a published outdoor, burial, in-wall or public-space fire rating.
Best-practice checklist
What to do
Protect the connection and make later diagnosis straightforward.
- Use the female socket only with a standard, undamaged male RJ45 patch-cable plug.
- Support the inline junction on a desk, tray or cable-management point.
- Keep the joined channel as simple and short as practical.
- Test the original cable, extension and ports separately if speed drops.
- Leave broad bends at the female housing and the male strain relief.
- Keep the junction dry, accessible and away from heat or moving furniture.
A labelled, supported and tested connection is easier to maintain than one hidden immediately after purchase.
Avoid these mistakes
What not to do
Most failures come from wrong interfaces, unsupported claims, strain or uncontrolled channel changes.
- Do not leave the female socket hanging from a device port.
- Do not daisy-chain several extensions or couplers when one correct-length cable is available.
- Do not crush, staple, trap or sharply bend the cable or inline socket.
- Do not force telephone or non-RJ45 plugs into the female socket.
- Do not assume the extension increases internet speed or repairs a damaged cable.
- Do not install outdoors or inside a wall without the required documented rating.
Stop using the product if a connector, housing, jacket or lead is cracked, loose, contaminated, unusually hot or exposes conductive parts.
Read before installation
Warnings and limitations
The following limits remain important even when the connector appears to fit.
- Every extra junction adds contact points and can reduce channel margin.
- The complete link is limited by the slowest port, lowest-category cable and total channel length.
- The 250MHz figure is the exact current Category 6 reference used here; a conflicting 550MHz phrase is not relied upon.
- No outdoor, direct-burial, in-wall, plenum, LSZH or fire-resistance rating is stated for this exact product.
- Stop using the extension if the female housing, plug latch, jacket or strain relief becomes cracked, loose or unusually hot.
- PoE use is not promised because an exact class, wattage and installation rating are not published.
Exact-model specification table
Technical specifications
| Product type | RJ45 male-to-female Ethernet extension cable |
|---|---|
| SKU | 11282 |
| Length | 3m |
| Source-side interface | RJ45 female inline socket |
| Destination-side interface | RJ45 male plug |
| Signal direction | Bidirectional Ethernet data |
| Category | Cat6 |
| Precise shielding | F/UTP |
| Maximum listed speed | Up to 1000Mbps (1Gbps) |
| Frequency reference | 250MHz Category 6 reference in exact artwork |
| Conductors | 8 × 26AWG stranded pure-copper conductors arranged as four twisted pairs |
| Gauge | 26AWG |
| Cable form / size | Round; Approximately 6.2mm on the exact product record |
| Contacts / housing | 1 × shielded RJ45 male plug and 1 × RJ45 female inline socket with gold-plated contact wording |
| Jacket / colour | Black PVC; black |
| Driver / external power | None required |
| Installation ratings not stated | Outdoor, direct burial, in-wall, plenum, LSZH and fire-resistance |
“Not stated” means the current exact product sources do not safely establish that detail; it is intentionally not filled from another family model.
What is in the pack
Package contents
1 × UGREEN 3m Cat6 F/UTP RJ45 male-to-female extension cable (SKU 11282)
Included only as stated for this exact current product record.
Routers, computers, printers, network cables, USB adapters, installation hardware and power supplies are not included unless individually listed above. Inspect the retail package before installation.
Problem-to-check sequence
Troubleshooting guide
| No link after extension | Test the original cable directly, reseat the male-to-female junction, then test the extension with known-good ports. |
|---|---|
| Link falls to 100Mbps | Inspect all eight contacts, replace a damaged original cable and confirm every port supports gigabit auto-negotiation. |
| Connection changes when moved | Support the female housing and remove strain; intermittent movement sensitivity usually indicates a loose or damaged connector. |
| Internet is still slow | Test a local transfer and router link speed. The extension cannot exceed the broadband plan or network equipment. |
| PoE device does not power | Use only a cable and connection path whose exact PoE class and installation requirements are verified; this page makes no PoE promise. |
Change one variable at a time. A known-good direct connection is the fastest way to separate a product fault from a port, cable, driver, address or network problem.
Collapsible answers
Product-specific FAQ
Open any question for a concise answer about exact SKU 11282.
Which end connects to the existing cable?
Insert the existing patch cable’s male RJ45 plug into the extension cable’s female socket, then connect the extension’s male plug to the destination port.
Is the Ethernet signal directional?
No. Ethernet data is bidirectional, although the male-to-female physical arrangement gives the extension a specific connection sequence.
Can it support gigabit Ethernet?
It is listed for up to 1000Mbps when the complete joined channel, both cables, every connector and both ports support gigabit.
What bandwidth figure is used for this Cat6 cable?
The current exact artwork uses the Category 6 reference of 250MHz. A separate 550MHz phrase is not relied upon because it conflicts with the exact current performance artwork.
Does the extension improve a weak signal?
No. It is passive and does not amplify, regenerate or correct an existing cable fault.
Can I join several extension cables?
A single correct-length patch cable is preferable. Each junction adds contacts and length, so daisy-chaining can reduce channel margin and reliability.
Will it work with consoles and smart TVs?
Yes, when the device has a standard RJ45 Ethernet port and the full link is configured correctly. It cannot add Ethernet to a USB-only device.
Does it require software or power?
No. It is a passive copper Ethernet lead with no driver or external power requirement.
Is PoE supported?
No exact PoE class or wattage is verified, so this page does not promise PoE use.
Can it be routed outdoors or in a wall?
No outdoor, burial, in-wall, plenum, LSZH or fire rating is published for this exact SKU.
What should I check if the link drops to 100Mbps?
Test the original cable directly, inspect all eight contacts, confirm every port supports gigabit and replace any damaged or lower-category component.
What is included?
One 3m UGREEN 11282 Cat6 male-to-female Ethernet extension cable is listed. A separate original patch cable is required.
Exact-model verification
Research and source note
The exact current title establishes a 3m Cat6 F/UTP male-to-female extension cable rated up to 1000Mbps. Current artwork identifies the Category 6 reference as 250MHz and shows pure-copper twisted pairs, while the product record specifies 26AWG stranded copper and approximately 6.2mm outside diameter. A separate 550MHz phrase is excluded because it does not agree with the exact current Cat6 performance artwork.
The current Shopify record and all 7 exact product-owned gallery items were checked. Only exact-SKU media is embedded, once each at most, as a large contextual figure with unique alternative text and caption.
